Re: dvb with Pinnacle PCTV Sat

Am Donnerstag, 3. März 2005 23:23 schrieb Nico Sabbi:
> rightfully, I programmed to avoid it :)
> (in case you didn't notice I was kidding).

:) I noticed

>
> >>>any ideas what is the problem here.
> >>>
> >>>
> >>>Lukas
> >>
> >>what versio of mplayer? did you use a fresh cvs checkout?
> >>what frontend does your card mount?
> >
> >mplayer version:
> >MPlayer 1.0pre6-3.4.3-20050110 (C) 2000-2004 MPlayer Team
> >CPU: Advanced Micro Devices Athlon MP/XP Thoroughbred (Family: 6,
> > Stepping: 1) Detected cache-line size is 64 bytes
> >CPUflags:  MMX: 1 MMX2: 1 3DNow: 1 3DNow2: 1 SSE: 1 SSE2: 0
> >Compiled for x86 CPU with extensions: MMX MMX2 3DNow 3DNowEx SSE
> >
> >it is not cvs.
>
> it's recent enough. What's the content of your ~/.mplayer/channels.conf?
> do you know that mplayer interprets the diseqc parameter differently
> from szap?
# cat ~/.mplayer/channels.conf.sat |grep ZDF
ZDF:11953:h:0:27500:110:120:28006

it seems using disec 0. I have only one LNB. But there is a multiswitch. 
between lnb and satcard.

I think you asked of diseqc because of

DISEQC SETTING FAILED

in szap i get following message. I think it is the same

FE_DISEQC_SEND_BURST failed: Operation not supported


> it has to be either 0 (no diseqc) or n=1..4 where n is the lnb position
> (e.g. 1 for position 1
> and so on).
> If after verifying this config the problem persists post me the
> compressed log  of
>
> mplayer -v dvb://ZDF
>
> please.

_______________________________________________
MPlayer-dvb mailing list
[email protected]
http://mplayerhq.hu/mailman/listinfo/mplayer-dvb