Re: configure for arm problem

for me this has worked:

./configure --with-prefix=arm-linux --host=arm-linux


Olcay Korol wrote:

>Hi all,
>
>When i run the script below, i get an error message
>
>CC=arm-linux-gcc LD=arm-linux-ld NM=arm-linux-nm AR=arm-linux-ar \
>RANLIB=arm-linux-ranlib ./configure  --host=arm-linux
>
>  
>
>>>configure: error: cannot link a test picogui program.
>>>      
>>>
>
>Am i doing something wrong with the configure options?
>(The version of picogui i use is 0.45.)
>
>Olcay Korol
>
>
>-------------------------------------------------------
>This SF.net email is sponsored by:  Etnus, makers of TotalView, The best
>thread debugger on the planet. Designed with thread debugging features
>you've never dreamed of, try TotalView 6 free at www.etnus.com.
>_______________________________________________
>Pgui-devel mailing list
>[email protected]
>https://lists.sourceforge.net/lists/listinfo/pgui-devel
>  
>




-------------------------------------------------------
This SF.net email is sponsored by:  Etnus, makers of TotalView, The best
thread debugger on the planet. Designed with thread debugging features
you've never dreamed of, try TotalView 6 free at www.etnus.com.