Logging the message body

Hi,

I am using NIST SIP proxy & Trace-Viewer.

When I start traceviewer with command " java -jar tracesviewer.jar
-debug_file ..\debug\debug_log.txt ", it shows me the call-flow in
graphical fashion.But it doesn't show the message body content.

Is there any way to configure the stack so that it will log the message
body as well ?

Regards,
Kedar


============================================================================================================================

Tech Mahindra, formerly Mahindra-British Telecom.


Disclaimer:


The contents of this E-mail (including the contents of the enclosure(s) or attachment(s) if any) are privileged and confidential material of Tech Mahindra and should not be disclosed to, used by or copied in any manner by anyone other than the intended addressee(s). In case you are not the desired addressee, you should delete this message and/or re-direct it to the sender. The views expressed in this E-mail message (including the enclosure(s) or attachment(s) if any) are those of the individual sender, except where the sender expressly, and with authority, states them to be the views of Tech Mahindra.


This e-mail message including attachment/(s), if any, is believed to be free of any virus. However, it is the responsibility of the recipient to ensure that it is virus free and Tech Mahindra is not responsible for any loss or damage arising in any way from its use.

============================================================================================================================

_______________________________________________
nist-sip mailing list
[email protected]
http://www-x.antd.nist.gov/mailman/listinfo/nist-sip