Re: Releasing 1.38

Dave Rolsky <[email protected]> Sat, 15 Dec 2007 11:42:08 -0600 (CST)
Newsgroups gmane.comp.web.mason.devel
Message-ID <[email protected]>
On Sat, 15 Dec 2007, Dave Rolsky wrote:

> I also refactored the live apache tests quite a bit, so if folks could run
> these with (mp1 & 2 or both) that'd be great.

I did notice that the tests are pretty sensitive to having certain Apache 
modules enabled in a certain order to all pass. Specifically, I think you 
have to load/enable mod_perl _after_ mod_dir to get things passing. This 
is a well known problem when trying to use Mason's dhandlers under 
mod_perl.

Unfortunately, the tests are not smart enough to figure this out, so they 
just run and fail, rather than fixing things up in their own config.


-dave

/*===================================================
VegGuide.Org                        www.BookIRead.com
Your guide to all that's veg.       My book blog
===================================================*/

-------------------------------------------------------------------------
SF.Net email is sponsored by:
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services
for just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace