Re: Releasing 1.38

Was this an existing problem, or a new one caused by the refactored?  
And is this documented somewhere with the tests?

On Dec 15, 2007, at 9:42 AM, Dave Rolsky wrote:

>
> I did notice that the tests are pretty sensitive to having certain  
> Apache
> modules enabled in a certain order to all pass. Specifically, I  
> think you
> have to load/enable mod_perl _after_ mod_dir to get things passing.  
> This
> is a well known problem when trying to use Mason's dhandlers under
> mod_perl.
>
> Unfortunately, the tests are not smart enough to figure this out,  
> so they
> just run and fail, rather than fixing things up in their own config.
>
>
> -dave
>
> /*===================================================
> VegGuide.Org                        www.BookIRead.com
> Your guide to all that's veg.       My book blog
> ===================================================*/
>
> ---------------------------------------------------------------------- 
> ---
> SF.Net email is sponsored by:
> Check out the new SourceForge.net Marketplace.
> It's the best place to buy or sell services
> for just about anything Open Source.
> http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/ 
> marketplace
> _______________________________________________
> Mason-devel mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/mason-devel
>


-------------------------------------------------------------------------
SF.Net email is sponsored by:
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services
for just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace