Re: help for adding javascript in viewml

The original intent for JS support with ViewML was to support anything that 
kde's kfm did - which is to say, not much. ViewML isn't based on the konq 
code base, but the old kfm one (much smaller). This supported a limited 
javascript (for things like mouse overs) but not much else.

Adding "full" JS support to ViewML would take some effort. The framework is 
there, but none of the backend to really support it is present, currently. I 
would start with the existing JS code entry points, then toss all of the 
existing code to plug in something else. Unfortunately, I don't quite know 
what I'd put in it's place. Does anyone have any input on this?

Jason Kingan
Century Software


On Sunday 15 August 1999 08:00 pm, you wrote:
> I want to add javascript support to viewml, any kind of advice is
> appreciated.
>
>
> It seems that part of viewml is from kde's konqueror browser, but I am not
> clear about the effect of viewml's source code in jscript directory. These
> source code seems odd and I doubt if viewml can support minimal javascript
> just as it is said on webpage.

#############################################################
This message is sent to you because you are subscribed to
  the mailing list <[email protected]>.
To unsubscribe, E-mail to: <[email protected]>
To switch to the DIGEST mode, E-mail to <[email protected]>
To switch to the INDEX mode, E-mail to <[email protected]>
Send administrative queries to  <[email protected]>