Re: I have had to reinstall after totally removing ECCO PRO and get a blocking error message

Chris,

I searched far and wide for the files and can find none anywhere after 
extensive searching. The program is not making any new ones.  I am using 
Windows 7 not 10.

Any suggestions.  I also cannot find anywhere on the the group site to 
down load Ecco Pro 4.01 or the program that slang developed. Do you know 
where they are?

Thanks again.

Ray Yerkes


On 1/22/2018 5:14 PM, 'Christopher J. Holly, Attorney at Law' 
[email protected] [eccopro] wrote:
>
> Ray, search for ecco.cfg and ecco.fdb. For reasons I do not understand,
> sometimes these become corrupted or something. I would rename them just
> in case that is not it. Ecco will create new versions. Pay attention to
> where Windows puts those two files. In Win10 they go into a VirtualStore
> folder somewhere. Not sure about Win 7. --Chris
>
> On 01/21/2018 20:25 PM, '[email protected]' [email protected]
> [eccopro] wrote:
> > [Attachment(s) <#TopText> from [email protected] included below]
> >
> > I am a long time member of the original ECCO PRO Group. I installed 
> from
> > a old stored program for Window 7 in my Windows 7. I moved a couple of
> > *.eco files in and they worked fine until I tried to close them and I
> > get an error message "Unable to read or write configuration file." I
> > have not created master files and other to export, nor have I fiddled
> > with any of the files.  Is the config file in with the data or in the
> > program? How can I fix this.
> >
> > Ray Yerkes
> >
> >
> >
> >
> >
>
>