[[email protected]: Re: mechanical computation: with Merkle gates, height fields, and thread]
Kragen Javier Sitaker <[email protected]>
| Newsgroups | gmane.culture.people.kragen.discuss |
|---|---|
| Message-ID | <[email protected]> |
----- Forwarded message from Don Marti <[email protected]> ----- From: Don Marti <[email protected]> To: Kragen Javier Sitaker <[email protected]> Subject: Re: mechanical computation: with Merkle gates, height fields, and thread Kragen, > On Mon, Jun 28, 2010 at 09:00:36AM -0700, Don Marti wrote: > > Some 3d printers will print a mix of low-melting-point > > and high-melting-point voxels (plastic and wax), > > so you take the object out of the printer and melt > > the wax out to get the finished product. > > > > You could also print a mix of water-soluble and > > water-insoluble material, or use a different solvent, > > or use a placeholder material that will react with > > some other reagent after printing. > > Neat ideas; I didn't know about the melting-point mix trick. Can I > forward this to kragen-discuss? Sure -- go ahead. Here's a printer that does it, by the way: http://www.3dsystems.com/products/multijet/invision/index.asp -- Don Marti http://zgp.org/~dmarti/ [email protected] ----- End forwarded message ----- -- To unsubscribe: http://lists.canonical.org/mailman/listinfo/kragen-discuss