Re: Service entry point debug with condition

I've never been able to get them to work.  It just hangs.


On Tue, Jul 15, 2025 at 1:38 PM David Gibbs via WDSCI-L <
[email protected]> wrote:

> Folks:
>
> Does anyone work with SEP debug with conditions?
>
> I'm trying to debug an RPG program, invoked from the web server, but
> only if a specific entry parameter has a specific value.
>
> If I set the condition for the SEP to "i_req.sessionid = 'dmgtest'",
> the job hangs ... but never enters debug.
>
> It appears that the job is TRYING to  enter debug, as the call stack
> shows 'QTESEPEH' as the last entry (immediately after the program I'm
> trying to debug), but it never gets any farther.
>
> After that, even if I remove the SEP condition, the program won't
> enter debug until I shut down RDi and re-launch it.
>
> Any suggestions?
>
> David
>
>
-- 
This is the Rational Developer for IBM i   (WDSCI-L) mailing list
To post a message email: [email protected]
To subscribe, unsubscribe, or change list options,
visit: https://lists.midrange.com/mailman/listinfo/wdsci-l
or email: [email protected]
Before posting, please take a moment to review the archives
at https://archive.midrange.com/wdsci-l.