Re: Service entry point debug with condition
Brian Parkins <[email protected]>
| Newsgroups | gmane.editors.websphere.iseries |
|---|---|
| Message-ID | <[email protected]> |
(I can't get RDi 9.8 SEP debug to work at all. Works fine with RDi 9.6 on the same V7.5 server - and all fixes applied. Thank goodness for STRDBG!) Brian. On 17/07/2025 13:33, Justin Taylor wrote: > I've never been able to get them to work. It just hangs. > > > On Tue, Jul 15, 2025 at 1:38 PM David Gibbs via WDSCI-L < > [email protected]> wrote: > >> Folks: >> >> Does anyone work with SEP debug with conditions? >> >> I'm trying to debug an RPG program, invoked from the web server, but >> only if a specific entry parameter has a specific value. >> >> If I set the condition for the SEP to "i_req.sessionid = 'dmgtest'", >> the job hangs ... but never enters debug. >> >> It appears that the job is TRYING to enter debug, as the call stack >> shows 'QTESEPEH' as the last entry (immediately after the program I'm >> trying to debug), but it never gets any farther. >> >> After that, even if I remove the SEP condition, the program won't >> enter debug until I shut down RDi and re-launch it. >> >> Any suggestions? >> >> David >> >> -- This is the Rational Developer for IBM i (WDSCI-L) mailing list To post a message email: [email protected] To subscribe, unsubscribe, or change list options, visit: https://lists.midrange.com/mailman/listinfo/wdsci-l or email: [email protected] Before posting, please take a moment to review the archives at https://archive.midrange.com/wdsci-l.