Re: VECTOR: Star Wars CPU D3 short

Or, just to take this a bit farther. Use one of those laser temperature 
probes to check the temp of all the IC's connected to D3. Im not sure 
how accurate they are but it would sure save a small blister. It would 
actually be interesting to see a specific IC jump in temp due to that.

[email protected] wrote:

> In a message dated 6/9/2005 5:33:46 P.M. Eastern Standard Time, 
> [email protected] writes:
>
>     Now that's a good idea.  Tie D3 to +5 volts and feel for the heat,
>     correct?
>
> Yep, I usually just use a clip lead to the end of a capacitor if 
> available, then have a pointy tip on the end of the wire and put it on 
> convenient point of the note.  It may get really hot, so wear glasses 
> and smell for the hot chip before burning the piss out of your hand.
>  
> Dave
>  
> +++++Ask me about Retrocade 30-in-1 MultiPac kits for Midway Pac Man 
> and Ms Pac Man boards and same kit already attached to a new JAMMA 
> PCB. Also we now have purchased the rights to WG6100 (Tempest, etc) 
> new deflection boards and HVU boards. Also HVU boards for Amplifone 
> (Star Wars). These are version 2 with no extra wiring or mods 
> necessary. Ask about Star Wars overlays and new cabinets for Midway 
> cocktail, upright, mini, Dragon's Lair, Williams, Golden Tee Fore, and 
> Ultra-MAME++++