Re: VECTOR: TECH: Battlezone Monitor Goes on and Off
Matthew Sell <[email protected]>
| Newsgroups | gmane.games.arcade.vector |
|---|---|
| Message-ID | <[email protected]> |
Pete,
Sounds like the monitor isn't the problem - try reseating the PROMs.
I bet the watchdog is resetting the CPU - causing the display to blank,
thus triggering the spot killer.
Just an observation.
- Matt
[email protected] wrote:
>Hi All
>
>I'm having a problem with a Battlezone. The monitor will
>always work in test mode but when switched to game mode the
>monitor will work for a bit then start switching on and
>off. The spot killer goes on and off with each cycle.
>Here's the "what's done" list:
>
>Recapped monitor and HV unit
>Reflowed solder joints on monitor and interconnect cable
>A/R board modified to eliminate 5V regulation circuity,
>voltage set to 5.1vdc at chips on PCB.
>
>Game was working fine until moved.
>
>Any help would be appreciated.
>
>Thanks in advance,
>Pete
>[email protected]
>---------------------------------------------------------------------------
>** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
>** Please direct other questions, comments, or problems to [email protected]
>
>
>
--
-------------------------
Matthew Sell
Programmer
UNIX System Administrator
On Time Support, Inc.
www.ontimesupport.com
Join the Metrology Software Discussion List METLIST!
http://www.ontimesupport.com/metlist.html
Growing old is mandatory; growing up is optional.
Today's mighty oak is just yesterday's nut that held its ground.