RE: VECTOR: Battlezone problems

Supposing that they are two different problems, I suggest you to check (or
change if you can't check) the 74244 in R11 position (or the 7404 in R9
position, but I don't think).
With a tester check resistors R128, R130, R132; the right value is 1K.

When you insert right  coin R132 is connected between ground and pin 11 of
74244
When you insert left   coin R128 is connected between ground and pin 15 of
74244
When you insert center coin R130 is connected between ground and pin 13 of
74244

This 74244 is the only interface between coins and 6502 data input. If it
works probably you have to check the bus and you may have problems with DIP
SW configuration too.

Let me know,
Marco

> -----Original Message-----
> From: [email protected] 
> [mailto:[email protected]] On Behalf Of Hendrix, Jeff
> Sent: mercoledì 29 settembre 2004 8.56
> To: [email protected]
> Subject: VECTOR: Battlezone problems
> 
> 
> I have a battlezone that works fine, except for 2 problems.
> The coin up doesn't work (not huge deal since I run in free 
> play). No sounds at all. I've checked all connections and 
> reseated chips.
> 
> Don't know if these 2 problems are related or not, but would 
> like any hints on where to start looking.
> 
> Thanks
> -jeff



---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to [email protected]