Re: VECTOR: TECH: G08 oddities, help me fix 'em
"Mark Jenison" <[email protected]>
| Newsgroups | gmane.games.arcade.vector |
|---|---|
| Message-ID | <[email protected]> |
Did you try swapping out the custom chip? Typically I see problems like this where the boardset's ribbon cable gets loose. ----- Original Message ----- From: "Hans O" <[email protected]> To: <[email protected]> Sent: Sunday, October 31, 2004 6:50 PM Subject: VECTOR: TECH: G08 oddities, help me fix 'em > Finally got to work on my G08s today. Two fixed with no problem. I got number 3 to work but it displays some curious wiggles... > > http://pweb.netcom.com/~p1001/TACSCAN_1.JPG > http://pweb.netcom.com/~p1001/TACSCAN_2.JPG > http://pweb.netcom.com/~p1001/TACSCAN_3.JPG > > Never seen this before. Lines have a little wiggle at the end (or beginning). Any ideas? > > Hans O > Dang doorbell, there it goes again... > -------------------------------------------------------------------------- - > ** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org > ** Please direct other questions, comments, or problems to [email protected] >