Re: VECTOR: TECH: G08 oddities, help me fix 'em
Mark E Davidson <[email protected]>
| Newsgroups | gmane.games.arcade.vector |
|---|---|
| Message-ID | <[email protected]> |
Speaking of custom chip, does anyone know what's inside that chip so that a replacement board could be made? (like clays AVG board) -=Mark=- Mark Jenison wrote: >Did you try swapping out the custom chip? > >Typically I see problems like this where the boardset's ribbon cable gets >loose. > >----- Original Message ----- >From: "Hans O" <[email protected]> >To: <[email protected]> >Sent: Sunday, October 31, 2004 6:50 PM >Subject: VECTOR: TECH: G08 oddities, help me fix 'em > > > > >>Finally got to work on my G08s today. Two fixed with no problem. I got >> >> >number 3 to work but it displays some curious wiggles... > > >>http://pweb.netcom.com/~p1001/TACSCAN_1.JPG >>http://pweb.netcom.com/~p1001/TACSCAN_2.JPG >>http://pweb.netcom.com/~p1001/TACSCAN_3.JPG >> >>Never seen this before. Lines have a little wiggle at the end (or >> >> >beginning). Any ideas? > > >>Hans O >>Dang doorbell, there it goes again... >>-------------------------------------------------------------------------- >> >> >- > > >>** Unsubscribe, subscribe, or view the archives at >> >> >http://www.vectorlist.org > > >>** Please direct other questions, comments, or problems to >> >> >[email protected] > > >--------------------------------------------------------------------------- >** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org >** Please direct other questions, comments, or problems to [email protected] > > > >