Re: VECTOR: SW monitor prob...

I have just read through the FAQ's for the WG6100 and in the flow chart it 
mention's the zd902 (zener diode) could this be the prob ?
Col,  if you have one of these can you send me one ?



Pinx

----- Original Message ----- 
From: "Christopher X. Candreva" <[email protected]>
To: <[email protected]>
Sent: Friday, April 01, 2005 10:19 PM
Subject: Re: VECTOR: SW monitor prob...


> On Fri, 1 Apr 2005, Pinx wrote:
>
>> I have a HV probe,
>> its what i used to discharge the monitor, so i could re-cap it. What 
>> voltage
>> should i set it to ?
>
> You would have to check the manual, I don't recall that off-hand -- and
> wouldn't trust my memory if I did.  There are several archives of PDF
> manuals. Also the old-reliable Greg Woodcock FAQ:
>
> http://www.westnet.com/~chris/arcade/F_Greg_Woodcock.html
>
>
> ==========================================================
> Chris Candreva  -- [email protected] -- (914) 967-7816
> WestNet Internet Services of Westchester
> http://www.westnet.com/
> ---------------------------------------------------------------------------
> ** Unsubscribe, subscribe, or view the archives at 
> http://www.vectorlist.org
> ** Please direct other questions, comments, or problems to 
> [email protected]
>