Re: VECTOR: SW monitor prob...

19500 Volts

At 01:14 PM 4/1/2005, you wrote:
>I have a HV probe,
>its what i used to discharge the monitor, so i could re-cap it. What 
>voltage should i set it to ?
>
>
>
>
>
>Pinx
>
>p.s.   Col, any parts you have would be much appreciated, also nice to see 
>you got the ESB working    :)
>
>
>----- Original Message ----- From: "Christopher X. Candreva" 
><[email protected]>
>To: <[email protected]>
>Sent: Friday, April 01, 2005 8:22 PM
>Subject: Re: VECTOR: SW monitor prob...
>
>
>>On Fri, 1 Apr 2005, Pinx wrote:
>>
>>>"blooming" and so i have just re-capped the HV section, but i still have
>>>the problem. Is there anything else on the HV board i should replace to
>>>cure this problem ?
>>
>>Re-capping isn't really a fix for blooming.  Blooming comes from voltage in
>>the HV section. The simple way to check that is with a HV probe, which can
>>be had for under $20 on e-bay usually.
>>
>>If it is low, it can be adjusted, the pot may have just slipped.
>>
>>==========================================================
>>Chris Candreva  -- [email protected] -- (914) 967-7816
>>WestNet Internet Services of Westchester
>>http://www.westnet.com/
>>---------------------------------------------------------------------------
>>** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
>>** Please direct other questions, comments, or problems to [email protected]
>
>---------------------------------------------------------------------------
>** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
>** Please direct other questions, comments, or problems to [email protected]