Re: VECTOR: Looking for p/n for neck board connector (Amplifone)

[email protected] Fri, 20 May 2005 10:54:25 EDT

Newsgroups	gmane.games.arcade.vector
Message-ID	<[email protected]>

 
 
In a message dated 5/20/2005 9:33:22 A.M. Eastern Standard Time,  
[email protected] writes:

Could you get a  board mount socket and solder wires to  it?


This is for a commercial project, so that wouldn't be too safe.
 
Thanks
 
Dave
 
+++++Ask me  about Retrocade 30-in-1 MultiPac kits for Midway Pac Man and Ms 
Pac Man boards  and same kit already attached to a new JAMMA PCB. Also we now 
have purchased the  rights to WG6100 (Tempest, etc) new deflection boards and 
HVU boards. Also HVU  boards for Amplifone (Star Wars). These are version 2 
with no extra wiring or  mods necessary. Ask about Star Wars overlays and new 
cabinets for Midway  cocktail, upright, mini, Dragon's Lair, Williams, Golden 
Tee Fore, and  Ultra-MAME++++