Re: CAP 13: Bad CAL-QUERY example / description?

On Wed, 2 Jun 2004 23:07:19 -0400, <[email protected]> wrote:

>
>        (d) Selects every property and every component
>         that is in any "VEVENT" component, with each "VEVENT"
>            component wrapped in a BEGIN/END VALARM tags.
>
> I strongly suspect that the bit about wrapping in BEGIN:VALARM/END:VALARM
> is residual from a previous example that was to contrast the (c) case
> above it.  I think that everything after the ',' on the second line  
> really
> should just be removed.  Or am I misunderstanding something?

>
>        (e) Selects all properties and all contained
>         components in all "VEVENT" components that have a "VALARM"
>         component with a "TRIGGER" property value between
>         the provided dates and times, with each "VEVENT"
>            component wrapped in a BEGIN/END VALARM tags.
>
> Again, Im not sure that the bits at the end about wrapping the VEVENT in  
> a
> BEGIN:VALARM/END:VALARM are correct.   Again, I think that everything

I've been looking at exactly the same section this morning.  Are you  
following me Bruce?

I think replacing 'in a BEGIN/END VALARM tags' with 'in BEGIN/END VEVENT  
tags' would fix this in both cases d) and e).  Unless I'm misunderstanding  
something as well ;)


-- 
Regards
Mike Higginbottom

Paul Smith Computer Services
01484 855800
[email protected]
www.pscs.co.uk