Re: CAP issue #657 (BEEP profile): closed?

"Preston Stephenson" <[email protected]> Wed, 04 Aug 2004 15:01:34 -0600
Newsgroups gmane.ietf.calendar
Message-ID <[email protected]>
The greeting message just says what is available.
You have to send a start message for a channel.
You have to have a channel to communicate.
Channel 0 is reserved for channel management.
For 2.3 of rfc3080
"When a BEEP session starts, only channel number zero is defined,
   which is used for channel management."

          C: <start number='1'>
          C:    <profile uri='http://iana.org/beep/cap/1.0'/>
          C: </start>

Where is the example of starting a CAP channel?

Again I need to see what the server responds to the start of a CAP
channel.
Thanks.

Preston

>>> [email protected] 08/04/04 2:33 PM >>>


Preston Stephenson wrote:

>There is a greeting that says CAP is supported, but there is not a
BEEP
>start channel for CAP.
>
Start one - per beep. You have the uri as specified in CAP:

    http://iana.org/beep/cap/1.0 

And BEEP: "2.3.1.2 The Start Message"

>BEEP communicates on channels.
>What channel will be for CAP?
>
Any where you started the channel with the uri = 
http://iana.org/beep/cap/1.0 

>The doc shows starting a channel for authentication, but that is for
>authentication not CAP.
>

CAP does not have its own authentication. It uses the BEEP SASL
profile
for authentication.

Once authentication is complete and valid, send a CAP greeting as
described in CAP "12.3 BEEP connection details", paragraph
that starts with "At this point ...". Once the greeting is accepted
you can open as many channels as you wish providing the CAP uri
for each channel.

 *** And again, I am not what I would call a beep expert. So if
something
is incorrect, please advice! ***

>In the BEEP (RFC3080) spec it shows starting a channel to do TLS.
>
>  
>
>>>>[email protected] 08/04/04 11:46 AM >>>
>>>>        
>>>>
>
>Is that not covered in "12.3 BEEP connection details" ?
>
>If not, what is missing?
>
>
>Preston Stephenson wrote:
>
>  
>
>>Sorry I haven't been getting copied for some time.
>>I still don't see how to start a BEEP channel for CAP in rev 13.
>>At least with my understanding of BEEP.
>>Preston
>>
>> 
>>
>>    
>>
>
>  
>

-- 

Doug Royer                     |   http://INET-Consulting.com 
-------------------------------|-----------------------------
[email protected]                 | Office: (208)520-4044
http://Royer.com/People/Doug   | Fax:    (866)594-8574
                               | Cell:   (208)520-4044

              We Do Standards - You Need Standards