Re: CAP issue #657 (BEEP profile): closed?

Preston Stephenson wrote:

>The greeting message just says what is available.
>You have to send a start message for a channel.
>You have to have a channel to communicate.
>Channel 0 is reserved for channel management.
>For 2.3 of rfc3080
>"When a BEEP session starts, only channel number zero is defined,
>   which is used for channel management."
>
>          C: <start number='1'>
>          C:    <profile uri='http://iana.org/beep/cap/1.0'/>
>          C: </start>
>
>Where is the example of starting a CAP channel?
>

I'll reword the text below to mention BEEP and the START command.

CAP: "10.7 GET-CAPABILITY Command"

   CMD: GET-CAPABILITY

   Purpose: The "GET-CAPABILITY" command returns the capabilities of the
   other end point of the session.

   A CUA MUST send a "GET-CAPABILITY" command to a CS after the initial
   connection. A CS MUST send a "GET-CAPABILITY" command to a CUA after
   the initial connection. The "GET-CAPABILITY" command and reply MUST
   BE implemented by all CSs and CUAs.




-- 

Doug Royer                     |   http://INET-Consulting.com
-------------------------------|-----------------------------
[email protected]                 | Office: (208)520-4044
http://Royer.com/People/Doug   | Fax:    (866)594-8574
                               | Cell:   (208)520-4044

              We Do Standards - You Need Standards