RE: Portal group discovery

 


________________________________

	From: William Studenmund [mailto:[email protected]] 
	Sent: Tuesday, October 03, 2006 5:28 PM
	To: Dan Bar Dov
	Cc: Sandars, Ken; [email protected]; John Hufferd; Julian Satran
	Subject: Re: [Ips] Portal group discovery
	
	
	On Oct 3, 2006, at 4:04 AM, Dan Bar Dov wrote:


		It is true that you cannot run two active connections in
the 
		same session when going through two routers.
		However, is it not possible to have a single active
connection, 
		and fail-over to a new (or a standby) connection ?


	The problem is that putting both routers in the same Target
Portal Group (TPG) means exactly that the initiator CAN have two active
connections, in the same session, through the two portals.

	So why do you want them in the same portal group? Why not just
give each router a different TPG and be done with it? 
	 
	If each target is in a different TPG, how do I achieve fail-over
between the routers? 
	(other than maintaining some heart-beat  between them, and
moving the router IP address over).
	 

	Take care,

	Bill

_______________________________________________
Ips mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/ips