[manet] Re: Questions about RFC 8175 (DLEP) Link Charact eristics Request message
Donald Eastlake <[email protected]> Mon, 30 Mar 2026 16:47:43 -0400
| Newsgroups | gmane.ietf.manet |
|---|---|
| Message-ID | <CAF4+nEFXRZ3DQ4mgDiFtR4fnfZ2fVTmius5=AxP_11i7y++kzA@mail.gmail.com> |
Hi Henning, Using the broadcast MAC seems like an elegant way to do this. I don't think there is any other plausible interpretation for that MAC address. Thanks, Donald =============================== Donald E. Eastlake 3rd +1-508-333-2270 (cell) 2386 Panoramic Circle, Apopka, FL 32703 USA [email protected] On Tue, Mar 24, 2026 at 5:40 AM Henning Rogge <[email protected]> wrote: > On Tue, Mar 17, 2026 at 8:22 AM Abdussalam Baryun > <[email protected]> wrote: > >> The issue we see is that the request we are talking about is for the > >> whole channel, not a special Destination. > > > > whole channel for the manet route > > whole channel of the radio attached over a DLEP session. > > >> RFC 8175 Section 12.18 defines that the referred destination of the > >> Link Characteristics Request message can be both real (e.g. remote MAC > >> address) or logical (e.g. multicast group). > >> > >> Would it be valid to use the "broadcast MAC" to request something for > >> the whole network or do we need a "Channel/Device Characteristic > >> Request/Response" message? > > > > I don't think we can use broadcast MAC for DLEP, so it will need > different protocol. > > We CAN use the broadcast MAC for a DLEP destination, thats not the > issue... the issue is if we SHOULD use this for using the "Request > Link Characteristic" Message for requesting new parameters for the > radio session or if we should use a new MESSAGE type for requesting > such a change. > > Not sure why you are talking about a different protocol. > > Henning Rogge > > _______________________________________________ > manet mailing list -- [email protected] > To unsubscribe send an email to [email protected] > _______________________________________________ manet mailing list -- [email protected] To unsubscribe send an email to [email protected]