Re: Error Code #511 "Temporarily Busy"

Thanks.

-----Original Message-----
From: Christian Groves [mailto:[email protected]] 
Sent: Wednesday, March 12, 2008 3:51 AM
To: Miri Epstein
Cc: megaco ietf
Subject: Re: Error Code #511 "Temporarily Busy"

Hello Miri,

This error code was introduced in 
http://www.itu.int/md/T05-SG16-060403-D-0303/en

511 was introduced to handle the MGC busy case, 510 is for the MG case. 
In the two sentences you refer to the last instance of "MG" is probably 
a typographic error.

Regards, Christian

Miri Epstein wrote:
> Hello Christian,
>
> This error code was added to H.248.8 [08/2007] and has the following
> description:
> "Definition: The command(s) was rejected due to a temporary busy
> condition in the MGC."
>
> First I thought this was a typo and it should have been MG instead of
> MGC.
>  
> Then I took a look at the "old implementor guide" (attached) and found
> the following text (clause 8.3):
> "H.248.8 defines Error Code 510 "Insufficient resources" to indicate
> that the MG can not execute the command due to lack of resources. The
> MGC may also experience temporary congestion of software resources.
> Therefore a new error code is proposed to indicate that the MG has
> temporary lack of resources to execute the command."
>
> It seems that there is no relation between the two last sentences.
Could
> you please explain this?
>
> May I suggest the following modification in the error description?
> Definition: The command(s) was rejected due to a temporary busy
> condition in the MGC/MG.
>
> Is there anything I've missed here?
>
> Thanks,
> Miri
>
>