Re: Move command

Hi,
 
Thanks,
both command in action are on different terminations ( move is on
physical while modify is on ephemeral ) so ordering shouldn't be an
problem.
 
Regards,
Rahul Ruikar
Alcatel-Lucent
Email: [email protected]
Alcanet: 2721 4732
 

________________________________

From: BEHAR ALDANA RONALD 
Sent: Thursday, March 13, 2008 3:03 PM
To: RUIKAR RAHUL A; [email protected]
Cc: Schwarz Albrecht
Subject: RE: [Megaco] Move command


You can send the two commands in the same message. In my opinion you
should place the move command before the modify since the MG will apply
the commands in the same order it receives them.
 
The comma after the move command is not required since you are not
sending another command, so the structure should be
 
T=12{
 C=cntx1{
  MV=Term1,
  MF=rtp/1{M{O{MO=SR}}}
  }
 }

 
regards

________________________________

De: [email protected] [mailto:[email protected]] En nombre
de RUIKAR RAHUL A
Enviado el: jueves, 13 de marzo de 2008 10:24
Para: [email protected]
CC: Schwarz Albrecht
Asunto: [Megaco] Move command


Hi All,
 
I have query regarding using MOVE command alongwith other commands in
same Megaco Action.
Example : 
                  there are 2 contexts( cntx1 and cntx2 )  on gateway
for termination Term1, SCN termination is in cntx2
now I want to move SCN termination to cntx1 and apply mode=<sendreceive>
on rtp termination of cntx1
 
Is following command valid..?
 
T=12{
 C=cntx1{
  MF=rtp/1{M{O{MO=SR}}},
  MV=Term1,
  }
 }

or Do I need to send these commands in separate actions. 
 
please suggest on this..
 
 
Regards,
Rahul Ruikar
Alcatel-Lucent
Email: [email protected]
Alcanet: 2721 4732

_______________________________________________
Megaco mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/megaco