Re: Issue #27: Allow RTP attributes in non-media m= sections
Christer Holmberg <[email protected]>
| Newsgroups | gmane.ietf.mmusic |
|---|---|
| Message-ID | <[email protected]> |
Hi, >See: >https://github.com/cdh4u/draft-sdp-bundle/issues/27 >https://github.com/rtcweb-wg/jsep/issues/528 > >The basic issue is that it's possible to have a situation where you have both >media and data m= sections but the BUNDLE tag is associated with the data >m= section and now you need to put the TRANSPORT and IDENTICAL >attributes somewhere. The JSEP editors discussed this and came to the >conclusion that it should go with the BUNDLE tag (i.e., in the data m= section) >and that BUNDLE should forbid this, but it requires a change to BUNDLE. Did you mean to say that BUNDLE should NOT forbid this? Based on your GitHub discussion, my understanding is that you want to allow to include RTP-specific parameters (‘rtcp-mux’, ‘rtcp’, ‘rtcp-mux-only’ attributes etc) in the data m= section. To repeat what I said on GitHub: This has been discussed in the past, and the outcome has been to now allow RTP-specific parameters in non-RTP m= sections. A solution would be to simply change the bundle tag when the RTP m= sections are added. …OR, we change the mux category for the RTP-specific parameters. But, that of course means they have to be added to every RTP m= section. Regards, Christer _______________________________________________ mmusic mailing list [email protected] https://www.ietf.org/mailman/listinfo/mmusic