Re: AD evaluation comments on draft-ietf-nsis-rmd-15

Gerald Ash <[email protected]> Sat, 27 Feb 2010 09:55:51 -0800 (PST)
Newsgroups gmane.ietf.nsis
Message-ID <[email protected]>
Georgios,
 
See below.
 
> The bandwidth parameter is just the translation of the T-MOD parameter to
> the bandwidth paramter. I will include the following information in the
> draft:
>
>   The bit format used for the <Bandwidth> parameter is shown below and
>   it is a translation of the <TMOD-1> parameter, see [QSP-T], to
>   specify bandwidth only, by setting, see [QSP-T]:
>     o  TMOD Rate-1 (r)= Peak Data Rate-1 (p)
>     o  TMOD Size-1 (b) = large
>     o  Minimum Policed Unit-1 (m) = large
>
>    0                   1                   2                   3
>    0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
>   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
>   |1|E|0|r|  Bandwidth ID         |r|r|r|r|          5            |
>   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
>   |  Peak Data Rate-1 (p) (32-bit IEEE floating point number)     |
>   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
>   |  TMOD Size-1 (b) (32-bit IEEE floating point number)          |
>   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
>   |  Peak Data Rate-1 (p) (32-bit IEEE floating point number)     |
>   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
>   |  Minimum Policed Unit-1 (m) (32-bit unsigned integer)         |
>   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
>   |  Maximum Packet Size-1 (MPS) (32-bit unsigned integer)        |
>   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+

Just to be clear, the "Bandwidth ID" = 1, which is the same value as the TMOD-1 parameter ID (= 1), as already assigned by IANA.  It is not necessary to define another QSPEC parameter ID.  What you are calling the "<bandwidth> parameter" is actually the TMOD-1 parameter with particular values.  Once again, it is required that all NSIS/NSLP/QOSM implementations send the TMOD-1 parameter in their QSPEC's. 

> Regarding the "large" values, I will specify them in Section 4.6.
 
OK.
 
Thanks,
Jerry

_______________________________________________
nsis mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/nsis