RE: Clarification On load sharing parameters
Saraswati Bose <[email protected]>
| Newsgroups | gmane.ietf.sigtran |
|---|---|
| Message-ID | <[email protected]> |
Hi Brian,
Q1: [SUA]: Can I have different SSN value for ASPs within same AS. If not how should I laod share from SG end? Should it be on avialbel active ASP basis or is there any other parameter to look for in the received ULP message since SLS is no where in SUA over SCTP?
Q2: [IUA]:Let IID is identical for all ASPS within AS. traffic mode=Load share
For the following configuration how tpomload share traffic?
ASP1: TEI=1. SAPI=1
ASP2: TEI=1. SAPI=2// active handling traffic
ASP3: TEI=1. SAPI=2// active handling traffic
Now suppose ASP2 goes inactive. Can I activate ASP1 and now laod share traffic among ASP1 and ASP3 though theire DLCI don't match?
Or is it a invalid configuration and if so then how to handle the situation?
Q3:[M3UA]: When SLS is identical for all ASP within AS then can I laod share traffic on avialble active ASPs basis or is there any other parameter to look for?
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
Sigtran mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/sigtran