Re: Clarification On load sharing parameters
"Brian F. G. Bidulock" <[email protected]>
| Newsgroups | gmane.ietf.sigtran |
|---|---|
| Organization | http://www.openss7.org/ |
| Message-ID | <[email protected]> |
Saraswati, Saraswati Bose wrote: (Thu, 15 Dec 2005 22:08:46) > > Hi Brian, > > Q1: [SUA]: Can I have different SSN value for ASPs within same AS. If > not how should I laod share from SG end? Should it be on avialbel > active ASP basis or is there any other parameter to look for in the > received ULP message since SLS is no where in SUA over SCTP? SSN is not a good basis for loadsharing. The SG has access to SLS which is a good basis for loadsharing. > Q2: [IUA]:Let IID is identical for all ASPS within AS. traffic > mode=Load share > > For the following configuration how tpomload share traffic? > > ASP1: TEI=1. SAPI=1 > > ASP2: TEI=1. SAPI=2// active handling traffic > ASP3: TEI=1. SAPI=2// active handling traffic > Now suppose ASP2 goes inactive. Can I activate ASP1 and now laod share > traffic among ASP1 and ASP3 though theire DLCI don't match? > Or is it a invalid configuration and if so then how to handle the > situation? Why do you need to loadshare for IUA? > Q3:[M3UA]: When SLS is identical for all ASP within AS then can I laod > share traffic on avialble active ASPs basis or is there any other > parameter to look for? Again, SLS is the only rational basis for loadsharing. It is the only loadshare parameter that will deliver ISUP messages relating to the same call, or SCCP messages relating to the same conversation or connection, to be delivered to the same ASP. See Appendix section A.2. --brian > > __________________________________________________ > Do You Yahoo!? > Tired of spam? Yahoo! Mail has the best spam protection around > http://mail.yahoo.com -- Brian F. G. Bidulock [email protected] http://www.openss7.org/