RE: Test 4.4 when testing M3UA at SGP

Great. Based on this, would you agree that the DESCRIPTION.3 is refering
to the ASP state at the ASP ?

DESCRIPTION.3 states "State of ASP should not change to ASP Inactive" 

-----Original Message-----
From: [email protected] [mailto:[email protected]] On
Behalf Of Tolga Asveren
Sent: Wednesday, February 15, 2006 12:37 PM
To: [email protected]
Subject: RE: [Sigtran] Test 4.4 when testing M3UA at SGP

Yes.

> -----Original Message-----
> From: [email protected] [mailto:[email protected]]On
> Behalf Of Trentadue, Tim
> Sent: Wednesday, February 15, 2006 1:50 PM
> To: [email protected]
> Subject: RE: [Sigtran] Test 4.4 when testing M3UA at SGP
> 
> 
> You are correct. The test I refer to comes from 
> draft-anshoo-test-spec-m3ua-01.txt
> 
> When reading the statement "the remote ASP state is changed to 
> ASP-INACTIVE in all relevant Application Servers", should I interperet

> from the perspective of the SGP? i.e.,
> 
> "the remote ASP state (at the SGP) is changed to ASP-INACTIVE in all 
> relevant Application Servers (at the SGP)" ??
> 
> 
> -----Original Message-----
> From: [email protected] [mailto:[email protected]] On 
> Behalf Of Tolga Asveren
> Sent: Wednesday, February 15, 2006 11:48 AM
> To: [email protected]
> Subject: RE: [Sigtran] Test 4.4 when testing M3UA at SGP
> 
> Tim,
> 
> I don't know which document this test case is from but I assume it is 
> one of the drafts prepared for interoperability testings(?), so I 
> believe it is a safer approach to refer to RFC/IG rather than to such 
> drafts.
> 
> 4.3.4.1 from M3UA IG
>   If an ASP Up message is received and internally the remote ASP is in
>    the ASP-ACTIVE state, an ASP Up Ack message is returned, as well
as,
>    an Error message ("Unexpected Message).  In addition, the remote
ASP
>    state is changed to ASP-INACTIVE in all relevant Application
Servers
>    and all registered Routing Keys are considered deregistered.
> 
> The above is the current officially expected behavior.
> 
> Note for IG update: Figure 3 misses this transition.
> 
>    Thanks,
>    Tolga
> 
> 
> 
> > -----Original Message-----
> > From: [email protected] [mailto:[email protected]]On
> > Behalf Of Trentadue, Tim
> > Sent: Wednesday, February 15, 2006 12:53 PM
> > To: [email protected]
> > Subject: [Sigtran] Test 4.4 when testing M3UA at SGP
> >
> >
> > The PURPOSE and TEST DESCRIPTION.3 of this test seem to contradict 
> > each other and I'm hoping somebody can clarify.
> >
> > PURPOSE states "and ASP state is moved to ASP-Inactive" - I assume 
> > this is from the perspective of SGP
> >
> > DESCRIPTION.3 states "State of ASP should not change to ASP
Inactive" 
> > - I assume this too is from the perspective of the SGP. If so, it 
> > contradicts the PURPOSE, right?
> >
> >
> >
> >
> >        + TEST NUMBER : 4.4
> >
> >        + TITLE : Invalid Message Handling
> >
> >        + SUBTITLE : ASPUP message in ASP-Active state
> >
> >        + PURPOSE: To check that if ASPUP message is received in 
> > ASP-Active
> >          state then ACK message is sent to AS and ASP
> >          state is moved to ASP-Inactive.
> >
> >        + TEST CONFIGURATION: A
> >
> >        + PRE-TEST CONDITIONS: SCTP association is established 
> > between SGP and
> >          ASP and ASP1 is Active. Arrange the data in AS such that
> ASPUP
> >          message is sent to the SGP on stream 0.
> >
> >         EXPECTED MESSAGE SEQUENCE :
> >          ASP                           SGP             SM + NIF
> >                                      ASP is Active
> >
> >         ASPUP      ---------------->
> >
> >                    <---------------   ASP-Up-Ack
> >
> >                                         Status Ind -------> AS 
> > Inactive
> >
> >                    <---------------   Error
> >                                       (Unexpected Message)
> >
> >         ASPAC      ---------------->
> >                                         Status Ind ------->
> >
> >                    <---------------   ASP-Active-Ack
> >
> >        TEST DESCRIPTION:
> >        1. Send ASPUP message to the SGP in ASP-Active state.
> >        2. Check A: An Error message with parameter Unexpected 
> > Message should
> >           be received at ASP.
> >        3. Check B: State of ASP should not change to ASP Inactive. 
> > Send ASPAC
> >           message with correct Type (Type is same as defined at SGP 
> > for the
> >           AS) and routing context P to the SGP and SGP should send
> >           ASP-Active-Ack.
> >
> > Tim Trentadue
> >
> >
> > _______________________________________________
> > Sigtran mailing list
> > [email protected]
> > https://www1.ietf.org/mailman/listinfo/sigtran
> >
> 
> 
> 
> _______________________________________________
> Sigtran mailing list
> [email protected]
> https://www1.ietf.org/mailman/listinfo/sigtran
> 
> 
> 
> _______________________________________________
> Sigtran mailing list
> [email protected]
> https://www1.ietf.org/mailman/listinfo/sigtran
> 


_______________________________________________
Sigtran mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/sigtran