Re: Reserved SI value in REG REQ message.

Hi brian ,

As per the RFC3332 section 3.4.5
             0 to 2   Reserved
             3     SCCP
             4     TUP
             5     ISUP
          6 to 8  Reserved
             9     Broadband ISUP
            10     Satellite ISUP
            11     Reserved
            12     AAL type 2 Signalling
            13     Bearer Independent Call Control
(BICC)
            14     Gateway Control Protocol
            15     Reserved

Then what should be the error code on receive REG REQ
with reserverd SI value.

Br,
--- "Brian F. G. Bidulock" <[email protected]>
wrote:

> Padmalochan,
> 
> The SI value 2 is not reserved.
> 
> What do you return for any other invalid or
> unsupportable
> routing key in a registration request?
> 
> Some possibilities:
>  
>   1 Error - Unknown
>   4 Error - Invalid Routing Key
>   5 Error - Permission Denied
>   6 Error - Cannot Support Unique Routing
>   7 Error - Routing Key not Currently Provisioned
>   8 Error - Insufficient Resources
> 
> Just about any REG RSP error is adequate.
> 
> --brian
> 
> Padmalochan Moharana wrote:             (Tue, 26 Sep
> 2006 23:29:48)
> > Hi Brian,
> > 
> > When server receive RES REQ message with SI value
> 1,
> > what should be the response to the message in
> M3UA, As
> > SI value 0-2 is reserverd in M3UA.
> > 
> > Regards
> > Padmalochan
> > 
> > 
> > __________________________________________________
> > Do You Yahoo!?
> > Tired of spam?  Yahoo! Mail has the best spam
> protection around 
> > http://mail.yahoo.com 
> 
> -- 
> Brian F. G. Bidulock
> [email protected]
> http://www.openss7.org/
> 


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com