Re: Reserved SI value in REG REQ message.
"Ambika Tripathy" <[email protected]>
| Newsgroups | gmane.ietf.sigtran |
|---|---|
| Message-ID | <[email protected]> |
Hi Brain
Below is my configuration of OPC and DEPC for ASP end.
OPC = 1.2.3
DPC = 2.3.4
what should be the value of Destination Point Code parameter for RK in REg
REQ message?
RFC -3332 section3.6.1 tells
"
Destination Point Code:
The Destination Point Code parameter is mandatory, and identifies
the Destination Point Code of incoming SS7 traffic for which the
ASP is registering. The format is the same as described for the
Affected Destination parameter in the DUNA message (See Section
3.4.1). Its format is:
"
Then the DPC value should be == 1.2.3 if i m not wrong.
Please clear my doubt.
--
Br,
Ambika Prasad Tripathy
Nethawk Networks
Cell: +91-94375 47730
On 9/27/06, Padmalochan Moharana <[email protected]> wrote:
>
> Hi Brian,
>
> When server receive RES REQ message with SI value 1,
> what should be the response to the message in M3UA, As
> SI value 0-2 is reserverd in M3UA.
>
> Regards
> Padmalochan
>
>
> __________________________________________________
> Do You Yahoo!?
> Tired of spam? Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com
>
> _______________________________________________
> Sigtran mailing list
> [email protected]
> https://www1.ietf.org/mailman/listinfo/sigtran
>
_______________________________________________
Sigtran mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/sigtran