Re: TID Label Issues - Issue #1

Lincoln,

The issue is that it is already specified in the RFC as (X)UDTS "routing
failure".

--brian

Haresign Lincoln wrote:                                           (Wed, 11 Oct 2006 15:54:06)
> Brian,
> 
> Good question.
> 
> In this case, I don't believe that "return on error" applies.
> Everything at the SCCP level is valid at this point and we are now doing
> TCAP processing.  There are really two options (and we have implemented
> them both).
> 
> 1) The SG can drop the message.  
> 
> 2) The SG can send and ABORT.
> 
> I would leave this issue as implementation specific.  However if you are
> interested in specifying this in the IG, I'd be happy to work on the
> wording.
> 
> Regards,
> Lincoln
> 
> 
> -----Original Message-----
> From: Brian F. G. Bidulock [mailto:[email protected]] 
> Sent: Wednesday, October 11, 2006 2:58 PM
> To: Haresign Lincoln
> Cc: Barry Nagelberg; [email protected]
> Subject: TID Label Issues - Issue #1
> 
> Lincoln,
> 
> Another issue:
> 
> RFC 3868 says:
> 
> 4.7.3.1.  TCAP traffic
> 
>    ....
> 
>    If an ASP is not available, the SG may generate (X)UDTS "routing
>    failure", if the return option is used.
> 
> But when I look at Q.713 (07/96) Section 3.13 Return Cause, my choices
> are:
> 
>    0 0 0 0 0 0 0 0   no translation for an address of such nature
>    0 0 0 0 0 0 0 1   no translation for this specific address
>    0 0 0 0 0 0 1 0   sybsystem congestion
>    0 0 0 0 0 0 1 1   subsystem failure
>    0 0 0 0 0 1 0 0   unequipped user
>    0 0 0 0 0 1 0 1   MTP failure
>    0 0 0 0 0 1 1 0   network congestion
>    0 0 0 0 0 1 1 1   unqualified
>    0 0 0 0 1 0 0 0   error in message transport (Note)
>    0 0 0 0 1 0 0 1   error in local processing (Note)
>    0 0 0 0 1 0 1 0   destination cannot perform reassembly (Note)
>    0 0 0 0 1 0 1 1   SCCP failure
>    0 0 0 0 1 1 0 0   hop counter violation
>    0 0 0 0 1 1 0 1   segmentation not supported
>    0 0 0 0 1 1 1 0   segmentation failure
>    0 0 0 0 1 1 1 1   |
>          to          |  spare
>    1 1 1 1 1 1 1 1   |
> 
>    Note - Only applicable to XUDT(S) message.
> 
> I don't see "routing failure" on the list.
> 
> Which one did you use?
> 
> --brian
> 
> --
> Brian F. G. Bidulock
> [email protected]
> http://www.openss7.org/

-- 
Brian F. G. Bidulock
[email protected]
http://www.openss7.org/