Re: RFC 4666 M3UA - Reg Request Message

"Brian F. G. Bidulock" <[email protected]> Mon, 6 Nov 2006 14:38:19 -0700

Newsgroups	gmane.ietf.sigtran
Organization	http://www.openss7.org/
Message-ID	<[email protected]>

Lincoln,

Well, I usually assign ISUP routing keys based on OPC/DPC pairings.
That way the CIC is significant, otherwise is certainly would not
be.  Note that OPC/DPC pairings still meets the TS 102 142
requirement.

--brian

Haresign Lincoln wrote:                      (Mon, 06 Nov 2006 16:26:03)
> Brian,
> 
> "did you look at the spec" 
> 
> Yes.
> 
> You say AS is on the basis of PC.  Do you mean OPC?  Or DPC?  
> 
> Again, the way I understand this is that each AS must have a routing
> criteria based upon either OPC or DPC and then you can use LOADSEL for
> loadsharing the CIC ranges within the AS.  Is that correct, or have I
> misunderstood?
> 
> Regards,
> Lincoln 
> 

-- 
Brian F. G. Bidulock
[email protected]
http://www.openss7.org/