RE: Re: about M2ua Adapted to ATM signal link

:-),Thanks,brain.

m2ua maybe can be adapted to m2pa link?

------------------------------------------------------------------
_________________________________________________________________
chen.puran,

Yes, of course MTP3b is supported.

RFC 3331:

1.4.1  Support for MTP Level 2 / MTP Level 3 interface boundary

   M2UA supports a MTP Level 2 / MTP Level 3 interface boundary that
   enables a seamless, or as seamless as possible, operation of the
   MTP2-User peers in the SS7 and IP domains.  An example of the
   primitives that need to be supported can be found in [10].

   ...

   [10] ITU-T Recommendation Q.2140, 'B-ISDN ATM Adaptation Layer',
        February 1995

1.5.4.1  SCTP Stream Management

   ...

   streams based on SLS.  This method may be of particular interest for
   high speed SS7 links (MTP3b) since high speed links have a 24-bit
   sequence number and the stream sequence number is 16-bits.

--brian

[email protected] wrote:
(Mon, 09 Jul 2007 18:45:57)
> hi,
>
> rfc3331,m2ua---->Message transfer part 2 User Adaptation layer  is for
mtp2
> protocol's user.
>
> but from m2ua protocol rfc3331,it can be Adaptation layer of signalling
> ATM Adaptation Layer's User  (ATM signal link)
>
>
>
> it can do ? can be contributed to rfc3331 as another selection?