Re: about M2ua Adapted to ATM signal link

chen.puran,

[email protected] wrote:                                                    (Mon, 09 Jul 2007 19:41:38)
> 
> 
> 
> :-),Thanks,brain.
> 
> m2ua maybe can be adapted to m2pa link?

Yes that too.  We removed references to M2PA from RFC 3331 because
M2PA was just a draft at the time RFC 3331 was released.

--brian

> 
> ------------------------------------------------------------------
> _________________________________________________________________
> chen.puran,
> 
> Yes, of course MTP3b is supported.
> 
> RFC 3331:
> 
> 1.4.1  Support for MTP Level 2 / MTP Level 3 interface boundary
> 
>    M2UA supports a MTP Level 2 / MTP Level 3 interface boundary that
>    enables a seamless, or as seamless as possible, operation of the
>    MTP2-User peers in the SS7 and IP domains.  An example of the
>    primitives that need to be supported can be found in [10].
> 
>    ...
> 
>    [10] ITU-T Recommendation Q.2140, 'B-ISDN ATM Adaptation Layer',
>         February 1995
> 
> 1.5.4.1  SCTP Stream Management
> 
>    ...
> 
>    streams based on SLS.  This method may be of particular interest for
>    high speed SS7 links (MTP3b) since high speed links have a 24-bit
>    sequence number and the stream sequence number is 16-bits.
> 
> --brian
> 
> [email protected] wrote:
> (Mon, 09 Jul 2007 18:45:57)
> > hi,
> >
> > rfc3331,m2ua---->Message transfer part 2 User Adaptation layer  is for
> mtp2
> > protocol's user.
> >
> > but from m2ua protocol rfc3331,it can be Adaptation layer of signalling
> > ATM Adaptation Layer's User  (ATM signal link)
> >
> >
> >
> > it can do ? can be contributed to rfc3331 as another selection?
> 

-- 
Brian F. G. Bidulock
[email protected]
http://www.openss7.org/