Re: m2ua: SG<->SG interoperation
"Brian F. G. Bidulock" <[email protected]>
| Newsgroups | gmane.ietf.sigtran |
|---|---|
| Organization | http://www.openss7.org/ |
| Message-ID | <[email protected]> |
emmanuel,
As below, SG1 to SG2 is M2UA. SG2 to MGC is M3UA.
--brian
****** SS7 ****** IP ****** IP ******
*SEP *-------* SG1*----------* SG2*-------*MGC *
****** ****** ****** ******
+----+ +----+
|S7UP| |S7UP|
+----+ +----+----+ +----+
|MTP3| |MTP3| | | |
+----+ +---------+ +----+ SIG| |SIG |
|MTP2| |MTP2|SIG | |SIG | | | |
+ + + +----+ M2UA +----+----+M3UA+----+
| | | | IP | | IP | | IP |
+----+ +----+----+ +----+----+ +----+
S7UP - SS7 User Part
Figure 10: SG to SG Case 1
emmanuel mavrommatis wrote: (Tue, 07 Aug 2007 16:40:22)
>
> Brian,
> I am talking about RFC 2719, 3.5 case 1 NOT 2, where SG1-----SG2. Is
> SG2 an ASP? What we should use there? Can we use M2UA here (case 1)??
> Thanks,
> Emmanuel
>
--
Brian F. G. Bidulock
[email protected]
http://www.openss7.org/