Re: Doubt abt usage of NOTIFY message.
"Mohammad Arif" <[email protected]>
| Newsgroups | gmane.ietf.sigtran |
|---|---|
| Message-ID | <[email protected]> |
Hi Ankit, Thanks, That means after sending ASP ACTIVE/ ASP INACTIVE we have to immediately send NOTIFY? Sending ASP ACTIVE means that particular AS is active so why sending Notify message again?. Its like using 2 messages to do one job.... I will be very grateful if you clarify this. Thanks On 10/26/07, Ankit Kumar Sharma <[email protected]> wrote: > > Arif, > > On 10/26/07, Mohammad Arif <[email protected]> wrote: > > > > Hi All, > > > > I have a scenario where in there are just two IPSPs ( IPSP1 and IPSP2) > > and each IPSP has just one AS. > > So do i need to send NOTIFY messages for change in IPSP AS states or > > just sending ASP_ACTIVE ans ASP_INACTIVE messages to remote IPSP is enough? > > > > As per protocol, you must send notify message to indicate changes in AS > state. Please refer to section 4.3.4.5 of RFC 4666 for more details. > > I think NOTIFY messages will come into picture only if there are more > > than two IPSPs. > > > > > > > > -- > > Regards > > Mohammad Arif > > > > Cheers, > Ankit > > -- Regards Mohammad Arif _______________________________________________ Sigtran mailing list [email protected] https://www1.ietf.org/mailman/listinfo/sigtran