Re: Doubt abt usage of NOTIFY message.
"Brian F. G. Bidulock" <[email protected]>
| Newsgroups | gmane.ietf.sigtran |
|---|---|
| Organization | http://www.openss7.org/ |
| Message-ID | <[email protected]> |
Mohammad, What's to clarify? You MUST send NOTIFY when AS state changes. So send them. --brian Mohammad Arif wrote: (Fri, 26 Oct 2007 13:48:46) > > Hi Ankit, > > Thanks, > > That means after sending ASP ACTIVE/ ASP INACTIVE we have to > immediately send NOTIFY? > > Sending ASP ACTIVE means that particular AS is active so why sending > Notify message again?. > > Its like using 2 messages to do one job.... > > I will be very grateful if you clarify this. > > > > Thanks > > > > On 10/26/07, Ankit Kumar Sharma <[1][email protected]> wrote: > > Arif, > > On 10/26/07, Mohammad Arif <[2] [email protected]> wrote: > > Hi All, > > > > I have a scenario where in there are just two IPSPs ( IPSP1 and IPSP2) > and each IPSP has just one AS. > > So do i need to send NOTIFY messages for change in IPSP AS states or > just sending ASP_ACTIVE ans ASP_INACTIVE messages to remote IPSP is > enough? > > As per protocol, you must send notify message to indicate changes in > AS state. Please refer to section [3]4.3.4.5 of RFC 4666 for more > details. > > I think NOTIFY messages will come into picture only if there are more > than two IPSPs. > > > > -- > Regards > Mohammad Arif > > > > Cheers, > > Ankit > > > -- > Regards > Mohammad Arif > > References > > 1. mailto:[email protected] > 2. mailto:[email protected] > 3. http://4.3.4.5/ -- Brian F. G. Bidulock [email protected] http://www.openss7.org/