Re: SCTP Port problem
Michael Tüxen <[email protected]>
| Newsgroups | gmane.ietf.sigtran |
|---|---|
| Message-ID | <[email protected]> |
Hi Richard, from the protocol point, you can use one SCTP end-point to setup association with multiple other SCTP end-points. However, sometimes there are SCTP implementation limitations... Best regards Michael On Nov 24, 2008, at 2:56 AM, Agonias, Richard L. (Digitel-GSM) wrote: > Hi Experts, > > Good Day! > > I’ve been using SCTP port 2905 for all of my M3UA connections. This > is from my Signaling gateway to my MSC-Servers for the MAP > applications. However, when I tried to create a new one for my new > association, it turned out to be refusing the port 2905. I tried to > change it to 2910 and it works. > > My question, is there any limitation in using the SCTP port for M3UA > like it can only be used for 100 connections? > > Thanks! > > Regards, > > richard > > > _______________________________________________ > Sigtran mailing list > [email protected] > https://www.ietf.org/mailman/listinfo/sigtran