Re: SCTP Port problem

Hi Michael,

Thanks for the reply.
Well I've been doing this as always. Setting up SCTP from one point and so as the other. However, there was one particular instance that SCTP port 2905 didn't work. So I tried changing it to 2910 and thus, resolved the problem.

Can you specify some SCTP implementation limitations?

Thanks in advance

Warmest regards,

RICHARD 


-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf Of Michael Tüxen
Sent: 2008-11-24 15:26
To: Agonias, Richard L. (Digitel-GSM)
Cc: [email protected]
Subject: Re: [Sigtran] SCTP Port problem

Hi Richard,

from the protocol point, you can use one SCTP end-point to setup  
association
with multiple other SCTP end-points.

However, sometimes there are SCTP implementation limitations...

Best regards
Michael

On Nov 24, 2008, at 2:56 AM, Agonias, Richard L. (Digitel-GSM) wrote:

> Hi Experts,
>
> Good Day!
>
> I've been using SCTP port 2905 for all of my M3UA connections. This  
> is from my Signaling gateway to my MSC-Servers for the MAP  
> applications. However, when I tried to create a new one for my new  
> association, it turned out to be refusing the port 2905. I tried to  
> change it to 2910 and it works.
>
> My question, is there any limitation in using the SCTP port for M3UA  
> like it can only be used for 100 connections?
>
> Thanks!
>
> Regards,
>
> richard
>
>
> _______________________________________________
> Sigtran mailing list
> [email protected]
> https://www.ietf.org/mailman/listinfo/sigtran

_______________________________________________
Sigtran mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/sigtran