Re: SCTP Abort

... the log file can be read by Wireshark. I think it
is in .pcap format.

Best regards
Michael

On Feb 26, 2009, at 11:53 AM, Ankit Kumar Sharma wrote:

> There are junk values in sctp.log file. What is the format for this  
> file?
>
> What about the T-bit? is it set in abort msg?
>
> Please see SCTP RFC for more details on T-bit.
>
> Please look at the below link as well:
> https://www.ietf.org/mailman/private/sigtran/2009-January/000155.html
>
> Cheers,
> Ankit Kumar Sharma
> ARICENT
> On Thu, Feb 26, 2009 at 2:09 PM, Arvind Kumar  
> <[email protected]> wrote:
> Hello Sigtran Gurus!
> I am bringing Signaling Gateway Stack with Softswitch as follows:
>
>
>
>
>            Signaling Gateway -------------          Softswitch
>            192.168.103.160                                 
> 192.168.103.170
>
>     Association is established then goes down, softswitch  
> establishes the association (four way handshake), it brings up the  
> association, but suddenly Signaling Gateway is aborting the  
> association by sending SCTP ABORT. This is happening again and again.
> Surprising thing is that there is no reason in  ABORT msg.
> Could you please give me any clue regarding this.
>
> I have attached the log.
>
>
> Thanks & Regards,
> Arvind
>
>
>
>
>
>
>
> _______________________________________________
> Sigtran mailing list
> [email protected]
> https://www.ietf.org/mailman/listinfo/sigtran
>
>
> _______________________________________________
> Sigtran mailing list
> [email protected]
> https://www.ietf.org/mailman/listinfo/sigtran