Re: SCTP Abort
"Haresign Lincoln" <[email protected]>
| Newsgroups | gmane.ietf.sigtran |
|---|---|
| Message-ID | <849535E338E99741B7F7413F73253EDB0A1079F6@us-nj-mail1.comverse.com> |
The SG is aborting the connection after receiving an ASP Active (the log is an ethereal trace as Michael indicated). For some reason, the SG doesn't expect an ASP active. I've seen this on some SGs that are expecting to receive a REG REQ before ASP Active. Can you configure the softswitch to do Dynamic Registration? Regards, Lincoln From: [email protected] [mailto:[email protected]] On Behalf Of Arvind Kumar Sent: Thursday, February 26, 2009 3:40 AM To: [email protected] Subject: [Sigtran] SCTP Abort Hello Sigtran Gurus! I am bringing Signaling Gateway Stack with Softswitch as follows: Signaling Gateway ------------- Softswitch 192.168.103.160 192.168.103.170 Association is established then goes down, softswitch establishes the association (four way handshake), it brings up the association, but suddenly Signaling Gateway is aborting the association by sending SCTP ABORT. This is happening again and again. Surprising thing is that there is no reason in ABORT msg. Could you please give me any clue regarding this. I have attached the log. Thanks & Regards, Arvind _______________________________________________ Sigtran mailing list [email protected] https://www.ietf.org/mailman/listinfo/sigtran