Re: SCTP Abort
"Brian F. G. Bidulock" <[email protected]>
| Newsgroups | gmane.ietf.sigtran |
|---|---|
| Organization | http://www.openss7.org/ |
| Message-ID | <[email protected]> |
Arvind, Your log file shows both implementations using Adler32 checksum. The checksum was updated to CRC32c some years ago, why is it using Adler32? That is: a conforming SCTP configuration might be a better place to start... --brian Arvind Kumar wrote: (Thu, 26 Feb 2009 14:09:46) > > Hello Sigtran Gurus! > I am bringing Signaling Gateway Stack with Softswitch as follows: > Signaling Gateway ------------- Softswitch > 192.168.103.160 > 192.168.103.170 > Association is established then goes down, softswitch establishes > the association (four way handshake), it brings up the association, > but suddenly Signaling Gateway is aborting the association by sending > SCTP ABORT. This is happening again and again. > Surprising thing is that there is no reason in ABORT msg. > Could you please give me any clue regarding this. > I have attached the log. > Thanks & Regards, > Arvind > _______________________________________________ > Sigtran mailing list > [email protected] > https://www.ietf.org/mailman/listinfo/sigtran -- Brian F. G. Bidulock [email protected] http://www.openss7.org/