Re: A question about M3UA association setup between 1 ASP and 2 SGP

mosbah,

Although it may appear at first blush that RFC 3332 and RFC 4666
interoperate, they do not.  Someone in France is risking their
SS7 network to save a couple of bucks?  Tsk, tsk.

--brian

mosbah abdelkader wrote:                                            (Thu, 14 Apr 2011 16:21:32)
>    Hi Brian,
>    Dialogic SS7 stack still use rfc3332. A time ago, We have provided an
>    mono-homed M3UA stack implementing rfc3332 to a customer and they have
>    used it with France Telecom network and it works properly.
>    Now we are implementing the multi-homed version with connection to more
>    than one STP in the ASP side.
>    The message flow that I have sent in the first mail shows the
>    interaction of the ASP with 2 SGP (STP).
>    So, supposing we are using rfc3332, still this configuration correct
>    for the interaction between an ASP and 2 STP?
>    Any guidance is very appreciated.
>    --
>    BR
>    Abdelkader Mosbah
>    On Thu, Apr 14, 2011 at 6:34 AM, Brian F. G. Bidulock
>    <[1][email protected]> wrote:
> 
>      mosbah,
>      RFC 3332 is long obsolete.  Don't use it.  Your
>      implementation must meet RFC 4666 to be interoperable.
>      --brian
>      mosbah abdelkader wrote:                          (Thu, 14 Apr 2011
>      06:23:32)
> 
>    >    I want just to know if that config works with other
>    implementations.
>    >    On Thu, Apr 14, 2011 at 2:26 AM, Brian F. G. Bidulock
> 
>    >    <[1][2][email protected]> wrote:
>    >
>    >      mosbah,
>    >      What did you think was the matter with it?
>    >      --brian
>    >      mosbah abdelkader wrote:                     (Wed, 13 Apr 2011
>    >      16:06:57)
>    >
>    >    >    Hi,
>    >    >    I have an M3UA configuration where an ASP communicates with 2
>    SGP
>    >    >    (STP). The file attached describes the M3UA message flow
>    between
>    >    the
>    >    >    ASP and the 2 SGP.
>    >    >    Is this sequence correct regarding M3UA specifications?
>    >    >    I am using M3UA rfc3332.
>    >    >    Please help.
>    >    >    --
>    >    >    Best Regards
>    >    >    Abdelkader Mosbah
>    --
>    Brian F. G. Bidulock
>    [3][email protected]
>    [4]http://www.openss7.org/
> 
> References
> 
>    1. mailto:[email protected]
>    2. mailto:[email protected]
>    3. mailto:[email protected]
>    4. http://www.openss7.org/

> _______________________________________________
> Sigtran mailing list
> [email protected]
> https://www.ietf.org/mailman/listinfo/sigtran


-- 
Brian F. G. Bidulock
[email protected]
http://www.openss7.org/