Re: Stupid question on flow use in outbound

Christer Holmberg writes:

 > But: if B2BUA-X controls gate-X, and B2BUA-Y controls gate-Y, you need
 > to make sure both signalling and media reaches X - OR that both media
 > and signalling reaches Y. 

yes, unless B2BUA-X and B2BUA-Y talk to each other.  my point is that
you cannot write a sip spec that prohibits signalling and media from
using different paths/ip addresses.

if your environment is such that it will not work, then you have to
configure your UA in such a way that it always uses same path/ip
address.  i don't see how this would be a protocol issue.

-- juha
_______________________________________________
Sip mailing list  https://www.ietf.org/mailman/listinfo/sip
This list is for NEW development of the core SIP Protocol
Use [email protected] for questions on current sip
Use [email protected] for new developments on the application of sip