Re: [midcom] SNMPv3 as MIDCOM protocol: Opinions?
Wes Hardaker <[email protected]>
| Newsgroups | gmane.ietf.snmpv3 |
|---|---|
| Organization | Network Associates Laboratories |
| Message-ID | <[email protected]> |
>>>>> On Fri, 6 Dec 2002 17:30:51 -0800 (PST), Randy Presuhn <[email protected]> said: Randy> My recollection from several years ago was that for Randy> single-varbbind requests in a noAuth/noPriv configuration, we Randy> were geting about 100 per second on ancient hardware using Randy> SMUX, and proportionately less (due to greater overhead) with Randy> AgentX. Just for kicks, I ran 10000 requests of various kinds against the Net-SNMP stack (which is not a well optimized stack compared to the commercial vendors) and timed the results. This was on a 233 PIII laptop which was not idle by any means, so take the numbers with a grain of salt. MD5 and DES were used for auth and priv. sysContact.0 in the Master agent: GET GETNEXT SET AuthPriv 1277 1176 493 AuthNoPriv 1462 1475 514 SNMPv1/2c 3769 3467 675 sysContact.0 in a subagent: GET GETNEXT SET AuthPriv 772 596 304 AuthNoPriv 860 661 355 SNMPv1/2c 1461 1018 420 -- Wes Hardaker Network Associates Laboratories