[ACPI-sppt] SLOOOOW after Configuing kernel parameters
"Richard L. Mitchell" <[email protected]>
| Newsgroups | gmane.linux.acpi.support |
|---|---|
| Message-ID | <[email protected]> |
I have built .21-rc3 with the acpi .21-rc3 patch. When I boot, the boot lines after "Configuring kernel parameters" start coming out at once a minute or so. Booting with acpi=off boots at normal speed. This in on an eMachines M5305 notebook. Any ideas? Thanks. Regards, Rich Mitchell ------------------------------------------------------- This SF.net email is sponsored by: eBay Get office equipment for less on eBay! http://adfarm.mediaplex.com/ad/ck/711-11697-6916-5