[ACPI-sppt] Compaq Presario 2800 -ACPI sees everything but doesn't behave correctly

Hi,
I'm using the 2.4.20 Suse kernel and acpi revision
20030228.  I played with my dsdt table till acpi saw
all the devices, battery, temp sensor, lid button... 
When it boots all the information comes up fine;
however, when I say unplug/(plug it in) it the
ac_adaptor doesn't update.  The battery  changes
states but says that the new state is "unknown".  Also
although it sees the lid button it doesn't changes
anything if it is depressed or not.  So it seems that
it just doesn't refresh or respond correctly.  The
only error I'm getting on bootup it something related
to pci:

ACPI: Subsystem revision 20030228
PCI: PCI BIOS revision 2.10 entry at 0xf031f, last
bus=3
PCI: Using configuration type 1
    ACPI-0292: *** Info: Table [DSDT] replaced by host
OS
    ACPI-0261: *** Error: Could not install pci_config
handler for C03C, AE_ALREADY_EXISTS
    ACPI-0261: *** Error: Could not install pci_config
handler for C03C, AE_ALREADY_EXISTS
    ACPI-0261: *** Error: Could not install pci_config
handler for C03C, AE_ALREADY_EXISTS
ACPI: Interpreter enabled


Any help identifying the problem is appreciated.  Is
this still related to my dsdt table, a conflict with
some pci drivers, any ideas?
Thanks,
Moritz

__________________________________
Do you Yahoo!?
SBC Yahoo! DSL - Now only $29.95 per month!
http://sbc.yahoo.com


-------------------------------------------------------
This SF.net email is sponsored by: VM Ware
With VMware you can run multiple operating systems on a single machine.
WITHOUT REBOOTING! Mix Linux / Windows / Novell virtual machines at the
same time. Free trial click here: http://www.vmware.com/wl/offer/345/0