[Bug 103] New: X Windows chooses invalid refresh rate/resolution after install
bugzilla-daemon <[email protected]>
| Newsgroups | gmane.linux.arklinux.bugs |
|---|---|
| Message-ID | <[email protected]> |
https://bugzilla.arklinux.org/bugzilla/show_bug.cgi?id=103
Summary: X Windows chooses invalid refresh rate/resolution after
install
Product: Ark Linux
Version: 1.0 alpha6
Platform: i586 (PC, Intel)
OS/Version: All
Status: NEW
Severity: Normal
Affects: Overall Usability
Component: XFree86
AssignedTo: [email protected]
ReportedBy: [email protected]
QAContact: [email protected]
Description of Problem: After installing the ArkLinux 10 Alpha 6 distribution
to my evaluation system, I was not able to start the system. The installation
completed properly. However, when X Windows starts, my monitor screen goes
blank, and the power LED turns amber, but stays on. This is a indication that
shows that the monitor does detect a video signal, but the signal is not in the
range of resolutions/refresh rates that the monitor can display.
The video card in the system is a Diamond Viper 330 (NV Riva 128) and the
monitor is a Techmedia 14".
Version-Release number of selected component (if applicable):
How Reproducible: 100%
Steps to Reproduce:
1. Install Arklinux on system.
2. Reboot.
3.
Actual Results:
No display
Expected Results:
Display
Additional Information:
Are there any command line parameters that can be passed to Arklinux to
configure the diplay settings, such as the ones used it Knoppix Linux?
Otherwise, is there an easy way to coorect this besides logging in at a console
and going through XF86 setup, etc?
Thanks.
------- You are receiving this mail because: -------
You are the assignee for the bug, or are watching the assignee.
You are the QA contact for the bug, or are watching the QA contact.